Новости

B-CUBE Parameter Reset

https://ardupilot.org/copter/docs/common-parameter-reset.html This article shows several ways to reset all parameters to their default values.If you would like to restore any of the existing setup parameters, save them to a file...

B-CUBE Pixhawk:some motor not run

if you meet some motor not run.Please check the Servo Output Make sure the function of Motor is Motor 1..4. not other,if other select Motor then reboot to test. for...

B-CUBE How to use WIFI 2.0?

1.For APM flight controller. 2.For PIXHAWK flight controller. Please select the corresponding flight control and click to view the tutorial.

B-CUBE How to use WIFI V3.0?

The ESP32 are readily available Wi-Fi modules with full TCP/IP stack and microcontroller capability. DroneBridge for ESP32 offers a transparent and bi-directional serial to WiFi bridge.Typical WiFi range is ~50m-200m...

B-CUBE How to use wifi V2.0 for pixhawk?

1.How to connect? use 6P line connects to pixhawk flight controller. Due to the different firmware, some firmware, two ports can be used, some firmware can only use one of...

B-CUBE HOW to use wifi V2.0 for APM?

1.use 5pin Line connect to APM flight controller. 2.How to use? Please note：When using Wifi Radio Telemetry connection, it must use 3DR Power Module or 5V ESC to supply power...