Новости

B-CUBE APM2.8 without internal compass

How to upload firmware for APM? http://blog.rctoysky.com/?p=319 How to connect APM to Mission Planner? http://blog.rctoysky.com/?p=20 1.If want to use GPS module, the connection is as follows, 2.Use mission planner to calibrate apm....

B-CUBE APM2.8 with internal compass

The mission planner will no longer be compatible with APM flight control starting from 1.3.76. Please download versions lower than 1.3.76, such as 1.3.74.Download from here. https://firmware.ap.ardupilot.org/Tools/MissionPlanner/archive/MissionPlanner-1.3.74.msi How to upload...

B-CUBE How to connect apm to mission planner

The apm connects to PC, make sure you have installed the Misson Planner, and select the right port and baud rate. You can download Misson Planner from here, https://firmware.ap.ardupilot.org/Tools/MissionPlanner/archive/MissionPlanner-1.3.74.msi For...

B-CUBE HOW to use OLED for PIXHAWK

Use OLED for PIXHAWK, must follow these steps, Connect OLED to I2C port of Pixhawk Upload ardupilot firmware, at least 3.5 version, below 3.5 version will not be display. Use...

B-CUBE APM2.9 without internal compass,support PPM

APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supports PPM receiver protocols.Why use the PPM protocol? The communication speed is fast, the...

B-CUBE APM2.9 with internal compass,support PPM

APM2.9 is used in the same way as APM2.6, 2.8，the hardware is same. The benefit is that APM 2.9 supports PPM receiver protocols.Why use the PPM protocol? The communication speed...