B-CUBE RemoteID For Pixhawk 2.4.8 PRO 6C Flight Control Ardupilot Quadcopter ArduRemoteID OpenDroneID

RemoteID

RemoteID For PIXHAWK2.4.8: Used for Pixhawk2.4.8 Flight Control

RemoteID For PIXHAWK PRO: Used for Pixhawk PRO Flight Control

RemoteID For PIXHAWK 6C: Used for Pixhawk 6C Flight Control

Send as you select.

How to use RemoteID for ardupilot firmware?

Use for ardupilot, you should compile the code,

git clone --recurse-submodules https://github.com/ArduPilot/ardupilot.git
cd ardupilot
./waf configure --board FMUV3 --enable-opendroneid #FMUV3 is pixhawk2.4.8 and pixhawk PRO board, you can change other
./waf copter

To solve this problem, I have compiled the code, which you can download here,https://www.uavbb.com/firmware/remoteid/

Overview

RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module.

The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators.

Note: This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country.

Specification

• Radio module:

• • Espressif ESP-C3 module

  • Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)

  • FCC & CE certified radio module

• Firmware:

• • ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).

  • Supports upgrading firmware via the web interface (“OTA”)

• Supported in PX4 & Ardupilot

• Protocol: CAN & Serial

• Interface:

• 1x JST GH 4-pin CAN (CAN) port

  1x JST GH 6-pin TELEM (UART) port

• Antenna Connector type:

• On PCB: IPEX Connector

• Range: > 5km detection range*

• Power: 5V supplied from TELEM or CAN port

• LED lights: Bright RGB status LED

• Size:

• 35.3 x 23.5 mm (not including antenna)

• Mount: M2 screws

• Operating temperature: -40°C to +85°C

• Weight:

• • PCB only: 4 g

  • With Antenna: 16.5g

• Certification: FCC& CE

* The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible.