News

B-CUBE How to upload firmware for APM?

1.install the Mission planner, you can download from here, https://firmware.ap.ardupilot.org/Tools/MissionPlanner/archive/MissionPlanner-1.3.74.msi 2.select the right COM port and 115200 baud rate. NOTE: the port cannot be seleted with AUTO or other. If...

B-CUBE PX4 avionic power low :4.30V

Some people may meet this problem,If this error causes the pixhawk to fail to arm, it is because the voltage value cannot be read from the 3DR power Module.This problem...

B-CUBE How to use 3DR Power Module for Pixhawk?

3DR Power Module can use 3S-6S batteries. 3DR Power Module can use 3S-6S batteries. It is recommended to use 3-4S batteries, if you use 6S batteries, you must pay attention...

B-CUBE pixracer

The Pixhawk® XRacer board family is optimized for small racing quads and planes. In contrast to Pixfalcon and Pixhawk it has in-built Wifi, new sensors, convenient full servo headers, CAN and supports 2M flash. Key...

B-CUBE 433MHZ:How to modify the parameters of r...

some people want to modify the the parameters of radio telemetry , but many people do wrong.It is not recommended to modify, use directly, wrong modification will lead to failure...

B-CUBE How to use M8N GPS for PIXHAWK

1.How to connect? 2. How to upload firmware ? should upload above 3.5 FMUV3 version firmware for PIXHAWK flight controller, below 3.5 or FMUV2 version firmware does not support for compass.So make sure you upload the...