News

B-CUBE Prearm Board 4.2V out of range 4.3-5.8V

If you use ardupilot firmware 4.0 or higher, you may encounter this problem. This is due to insufficient external power supply. The firmware above 4.0 needs to use the 3DR...

B-CUBE How to solve Check Board Voltage

1.For 3.4.6 version firmware Do not select Board Voltage at Arm_check parameter,then remember to click the “Write Params”Button. Then reboot he board. 2.For 4.0 above version firmware Set BRD_VBUS_MINI as...

B-CUBE 1000MW：How to use Radio Telemetry For PI...

1.use 6P line connects to pixhawk flight controller. Due to the different firmware, some firmware, two ports can be used, some firmware can only use one of the ports. So...

B-CUBE 1000MW:How to use Radio Telemetry?

Do not modify the parameters of radio telemetry , use it directly.   1.Use for APM flight controller. 2.Use for PIXHAWK flight controller. NOTE: 1.The Radio Telemetry is tested all OK...

B-CUBE OmnibusF4SD F4V3S flight controller

We have already uploded the betaflight firmware. If you use betaflight, you don’t need to upload the firmware. If you want to upload firmware, upload this version firmware. Select OMNIBUSF4SD  ...

B-CUBE Minim OSD Quick Installation Guide

https://ardupilot.org/copter/docs/common-minim-osd-quick-installation-guide.html MinimOSD “On-Screen Display” is a small circuit board that pulls telemetry data from your APM or Pixhawk autopilot and over-lays it on your First Person View monitor. This article provides brief instructions...